Questions & Answers

What is TDS ? Technical Data Sheet? If so, yes

We have quick ship models with built in redundant Nitrogen shut off, with the Synergy Nano temperature controller plus the safety limit controller, $8505 https://www.totaltemptech.com/quick-ship-products.

250 Lbs. includes palate

No, See FLIR.com

Yes, we have an adjustable high and low limit between -100 degrees C and +200 degrees C

$9890.00 https://www.totaltemptech.com/quick-ship-products/

No, See FLIR.com, we can also re-sell these.

Todays Refrigerants are +175 C max.

Typically 20C per minute ramping in either direction. Full duty cycle is not a problem, not an issue.

Hybrid chambers, being a specialty item, are not often rented but such is possible at a price. We can rent chambers on a per agreement basis, they can not be sold as new once rented. We currently offer some used chambers but they are not always available.

Standard model SD49 has maximum heating amperage of 14 amps, custom models up to 30A. are possible.

Pins 6 and 8 carry the heating current, up to 14A.. In the case of 30A. Models pins 12 and 2 also carry heating current up to 14A.

Yes, we have both the chambers and platforms capable of that, such as our CC230-N chamber and C144-N thermal platform.

We have a calibration procedure for the controller. Also, the sensor in the platform comes with NIST traceable calibration report.

Not currently. We are open to the possibility.

The solenoids can be rebuilt in place, the valve body rarely wears out. We recommend sending the platform in to us if the solenoid really needs to be replaced. Pipe fittings require special handling and a lot of care needed during the procedure.

Ask Your Question

Menu

Location

Call Us

Email Us

Questions & Answers

Do you have TDS products?

What is the price of the SD144 model?

What is the width of the C230 benchtop temperature chamber with a single stage refrigeration compressor?

Does the C230 benchtop temperature chamber with a single stage refrigeration compressor have an opening on both sides for the pull test?

How much does the C230 Benchtop Temperature Chamber with a single stage refrigeration compressor weigh?

Do you make custom temperature cameras?

Do you have a temperature limiter for a temperature between -55 degrees C and 85 degrees C?

What is the price of a 230c benchtop temperature chamber?

Do you have compact thermal cameras?

Do you have an air compressor temperature chamber of approximately 2? by 2? by 2? internally with a temperature range of -50C to 1000C as a minimum?

How fast can a heated platform cycle between 22C and 40C, and are there any duty cycle issues with constant cycling?

Do you have hybrid benchtop chambers for rent or sale?

What would be the maximum amperage through the connectors on the SD49 heat platform?

In case there is a power cable and a sensor cable connecting directly to the SD49, what is the expected amperage through each pin?

Do you have a small bench top unit that has a temperature range of at least -40 degrees Celsius to +125 degrees Celsius without N2 or CO2 gas?

Do you have a thermal map or drawing that shows where the heat and cooling coverage is on the plate?

Can you provide a drawing or picture of where the resistive heaters and cooling coils might be for the SD288?

Do you have any recommendations or technical notes for the SD288 calibration?

Do you have a rep in Canada?

Can you send a sample calibration certificate?

Would it be possible to purchase a replacement solenoid for the SD144 model, and replace it directly or does the platform have to be returned for repair?

Ask Your Question

Menu

Location

Call Us

Email Us